Pump.fun Maker Bot

Updated By PumpCrate

A Pump.fun maker bot raises the number of unique wallets that trade your coin. In PumpCrate it is the Makers mode: every fresh session wallet makes one buy and one sell of the size you pick, between 0.05 and 0.5 SOL, so a 100 SOL session at 0.1 SOL is 500 new makers. It is paid from the same prepaid pack as every other mode, with network fees and Jito tips included and no wallet signature needed to connect.

Plan it

Pick a preset, adjust it, then open the same plan in the panel with every field filled in.

Maker planner

Makers mode, 2 hours100 SOL volume

500 makers at 0.1 SOL each, about 8.3 trades a minute

PACE50 SOL/h
COMMENTS25% of orders
FAVORITES50% of wallets
TOKENS1
What this plan takes from each pack
PackPack value usedPlans like this per pack
Starter (2 SOL)0.4 SOL5
Growth (5 SOL)0.417 SOL12
Pro (10 SOL)0.333 SOL30
Open this plan in the panel

Planning numbers from your own inputs. The panel opens without a wallet, so you can check the plan before you buy anything.

Why makers matter

A maker is a wallet that traded the coin. Pump.fun shows trades wallet by wallet, and DexScreener lists unique makers next to volume and transactions. Traders read that number as a quick check on whether a chart is one wallet trading with itself or a crowd.

DexScreener says in its own documentation that unique makers are one of the market activity inputs to its Trending Score, together with volume, liquidity, transactions and holders. It does not publish the weights, so treat makers as one signal among several, not a switch.

Session wallets count as holders only while they hold the coin. The maker count is the figure that stays on the record after the run ends.

How Makers mode runs

Each Makers session funds a batch of brand new wallets with uneven amounts. Every wallet buys the coin once and sells it once at the size you chose, then hands back what is left. Orders go out through Jito bundles, spread over the run time, so the trade list fills with distinct addresses instead of a few repeat traders.

Maker count for sample Makers sessions
SessionBuy sizeRun timeNew makersTrades a minute
100 SOL0.1 SOL2 hours500about 8
300 SOL0.1 SOL6 hours1,500about 8
300 SOL0.25 SOL3 hours600about 7
500 SOL0.5 SOL12 hours500about 1.4

A smaller buy size gives more makers for the same volume. A larger one gives fewer wallets with heavier prints, which looks more like real buyers on a coin with a higher market cap.

Picking a buy size

  • 0.05 SOL suits a fresh coin on the bonding curve where most real buys are small too.
  • 0.1 SOL is the default and a good middle for most launches.
  • 0.25 SOL fits a coin that is close to graduating or already trading in PumpSwap.
  • 0.5 SOL fits a graduated coin with real liquidity, where tiny buys would look out of place.

If the goal is a short, dense window rather than a steady climb, the Trending push mode packs makers into 30 minutes to 3 hours.

Set up a maker run

  1. 1

    Open New session

    In the panel pick the Makers mode. No wallet is needed to look around.

  2. 2

    Add your coin

    Paste one mint, or several to split the balance across them.

  3. 3

    Choose buy size and run time

    The plan line shows the maker count and the trade pace for your numbers.

  4. 4

    Set comments and favorites

    Makers can also leave comments, favorite the coin and follow the creator, as a share of wallets.

  5. 5

    Start

    Connect your wallet only when you are ready to spend. Stop at any time to return the unspent volume.

What it costs

Makers mode has no per-maker fee. A 100 SOL Makers session costs 100 SOL of pack volume, which is 0.4 SOL of pack value at the Starter rate, about 0.42 SOL at Growth and about 0.33 SOL at Pro. Per-maker tools quote a rate per 100 makers and add gas on top, so compare the total, not the headline. The Smithii comparison works through an example.

Questions

What is a maker on Pump.fun?

A wallet that bought or sold the coin. DexScreener and most trading terminals show the unique maker count for a pair next to volume and transactions.

Are the makers real wallets?

They are real, brand new Solana wallets that trade on chain, and every buy and sell has a signature you can open on Solscan. They are funded by the session, not by outside buyers.

Can makers also comment?

Yes. Comments, favorites and creator follows are set as a share of orders and wallets, the same as in a volume run.

How many makers does 100 SOL buy?

At a 0.1 SOL buy size, 500. Each maker buys once and sells once, so it uses two times the buy size of session volume.

Do makers stay as holders?

Only until they sell. Holder count goes back down as the session wallets exit. The maker count stays.

Maker bot or volume bot?

A maker bot buys small from many wallets to raise the maker count. A volume bot uses mixed sizes to build traded volume. The mode guide shows which to pick for each goal.

Talk to usWe are offline right now, we reply by message
Instant answers on Telegram@pump_crate_bot

We forward it to our team and keep no copy on this site.